AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Rural king tool shed clearance3/28/2024 ![]() ![]() Strong governor response and clean output for a clone. Still testing longevity but currently has 4702 on the hour meter. would be a good companion to use during mantinence cycles for either a EU6500is or EU7000is (with load management) as well as a backup for the EM6500 it was cloned after. ![]() output is very clean, not quite as clean as EM6500 but close. Very impressive governor response for a clone, almost as snappy at picking up load shifts as a genuine EM6500, and the slight compression increase is noticeable in handling large surge loads. granted it has had a proper break in, MOS2 in oil, magnets in drainplugs and changed oil every 96 hours but still, that's a LOT of hours for a clone. ![]() this unit has 9731 on the hour meter and still fires right off. brushes need replaced after about 6000 hours, but are readily avalible, any clone brushes will fit. Tested Tool Shed SG6500E, GX390 clone, compression is a little higher than genuine GX390. Just wanted to let everyone know that this brand is something to watch for when shopping for clones. As clones go these seem to be some of the better units, as I have found out. ![]()
0 Comments
Read More
Leave a Reply. |